Control Board, Xilinx Spartan 6 Control Board, ADSP-BF527

Bildet er bare ment som illustrasjon. Se produktbeskrivelsen.

Produsentens varenummer:
HW-SDPB Series


Controller Board ADSP-BF527
HW-SDPB Series
Analog Devices
Finn lignende produkter Velg og endre egenskapene ovenfor for å finne lignende produkter.


The EVAL-SDP-CH1Z is a high speed controller board for system demonstration platform (SDP). The system demonstration platform is a collection of controller boards, interposer boards and daughter boards, used for easy, low cost evaluation. The EVAL-SDP-CH1Z has a Xilinx Spartan 6 and an ADSP-BF527 processor with connectivity to the PC through a USB 2.0 high speed port. Controller boards allow for the configuration and capture of data on daughter boards from the PC via USB. This board has a FMC low pin count connector with full differential LVDS and singled ended LVCMOS support. It also has the 120 pin connector, found on SDP-B which exposes the Blackfin processors peripherals. This connector provides a configurable serial, parallel I2C and SPI and GPIO communications lines to the attached daughter board. The PC side software application for controlling attached daughter board is provided with each of the daughter product evaluation boards or circuits from the lab reference circuits.
  • 32MB NAND flash memory
  • 8MB x 16bits x 4 banks (512MB/64MB) DDR2 memory
  • 256KB x 16bits (4MB/512KB) SRAM
  • 160 pin FMC LPC connector
  • 16MB x 16bits (256MB/32MB) SDRAM
  • Small footprint 120 pin connector
  • Configurable peripheral interfaces SPI, SPORT, I2C, GPIO, asynchronous parallel, PPI, timers
  • USB 2.0 interface to the PC
  • JTAG connector
  • LVDS and single ended LVCMOS signalling


Communications & Networking, Consumer Electronics


EVAL-SDP-CH1Z board, 1m USB standard A to mini B cable, 12V wall wart.


ESD sensitive device, take proper precaution while handling the device.

Tilknyttede produkter